Heat source

From BeerTools Pro Wiki
Revision as of 03:17, 16 January 2007 by Btp admin (talk | contribs)
Jump to navigation Jump to search

Heat sources include stoves, propane burners, and campfires. Always be careful when using heat sources.

Editor

Heatsource.jpg

Calibration

Here are the basic steps:

  1. Set your environment temperature to your ambient air temperature.
  2. Set calibration volume to the volume of test water used in the calibration vessel.
  3. The test vessel heat capacity can be determined from vessel calibration and if one has already been calibrated it will appear in the pop-up menu next to heat capacity.
  4. To run the test heat the water in the vessel to a temperature typical of your brewing process. For example it might be ideal to use a temperature on the low end of your saccharrification rest. Record your starting time or use a stop watch.
  5. Apply heat and determine how long it takes to raise the temperature 18F or 10C and enter that duration in the time to heat field.
  6. The heat transfer field above will update automatically.

Notes

One of the great things about Beertools Pro, is that you can use it to calibrate your burners to tell how long it will take to heat up your vessel, and calibrate the vessel to know the cool down rate and to what temperature. I did just that. I then went to my mash schedule to see what effects it would have. To my surprise it was pretty much dead on from my past brewing experiences. Jamie W.

See also